lay flat as much as possible, I used a brim to hold it down but as you can see it did curl 1 side but didn't do it the second time so meh, green stuff to the rescue. This is a work in progress it may require scaling up a little bit. that's up to you. I have not got any side weapons to print so using some off other models. This is approx the size or a rhino transport vehicle so may not be accurately sized to anything else it may be a proxy for. hope you like, I have grown quite fond of mine.
Printer Brand:
Ultimaker
Printer:
Ultimaker 2
Rafts:
No
Supports:
Yes
Resolution:
0.1
Infill:
20%
Notes:
only small amount of support needed on the chassis piece, most bits can be orientated to be flat or at a shallow angle to bed. brim adhesion and 20% infill.
