Herostrong3d uploaded a detailed digital sculpture of a "spiral dragon pillar". However the original model's pillar is off center and the dragon relief is separated from the pillar on one side. I solidified the model which now prints as one piece.
The dragon pillar is a classic Chinese architecture element. A reference picture is included. Let it decorate your desk!
Printer Brand:
Prusa
Printer:
i3 MK2S
Rafts:
No
Supports:
Yes
Resolution:
0.1mm
Infill:
10% 1 gradual step
Notes:
Print as tall as possible and at 0.1mm layer height to show maximum detail. Support everywhere at 75-80 degrees is necessary. Make sure to use a 1mm support interface otherwise support will be impossible to remove.
