Hi !
An attempt to print a proxy for the Swarmlord !
May be diffiult to print, in particular the swords. I'll probably post a version with thicker swords, easier to print with FDM.
Caution : use supports ( a lot) and print with fine resolution (0.1mm or less) or you won't get the details (teeth, fangs...)
assembled figure should be around 11cm high, I'm not 100% sure it is the correct size
Credits to tacihon for the original mesh.
I think making the conversion for hive tyrant would not be too difficult, but i'll need some advice and pictures.
== If you like my work please consider sending me some tips ==
Copyright infringement is not intended. All parts are created freehand in 3d modeling software, no copyrighted product had been scanned or copied in any way.
