THIS IS NOT MY ORIGINAL WORK. I only cut and adjusted the model from https://www.myminifactory.com/object/3d-print-to-print-hammer-of-sol-13941 to better fit my printer.
Nothing about the initial design is mine and all credit should go to Lloyd Roberts at myminifactory.
I cut the hammer head and hollowed out an area to fit a 3/4 inch or 19.05 mm dowel or pvc pipe. Hammer pommel should fit snugly onto the handle.
Printer Brand:
Prusa
Printer:
Rafts:
No
Supports:
Yes
Resolution:
.20mm
Infill:
10%-20%
Notes:
I rotated Hammer parts 1-4 to fit on the bed flat.
220 Grit sand paper over everything. Glued together with five minute epoxy. Seams filled with spot putty. Two coats of spray filler primer with sanding in between. And gunmetal silver paint with a gloss lacquer to seal everything.
