by Balthassar

I wasn't happy with the existing Litwick models available, so I made my own based on the ceramic Litwick box I already made.

There are two variants of the flame; one with a specific hollow for use with translucent filaments, and a solid one. I used the hollow one, but overestimated how translucent my purple filament was, so it's not visible.

Print Settings

Printer Brand:                          

TEVO

Printer:                          

Tarantula

Rafts:                          

Doesn't Matter

Supports:                          

Doesn't Matter

Resolution:                          

0.2mm

Infill:                          

10%

Notes:

It is possible to print both of the large parts upside-down without supports. There is a fairly large section that needs to be bridged on the main body when printed this way, but depending on how large you print, it should be fine; support as much or as little as you are comfortable with for a print job this size. If printed the correct way up, the arms will need supports.

You may require a brim or additional means of adhesion on the main body. I used a glue stick for that part.

The flame will print fine the correct way up.