by Skittles9370
The Phantom 1 from Star Wars REBELS. This is designed as a model kit. Extra details and painting required. Initially designed to full scale and reduced to 1/43 to match the Deagostini Millennium Falcon.
It's a nearly finished W.I.P. Just need to design a seat. Any other detailing of the exterior (Greeblies) or interior are up to you. I'm not doing ALL the work for you! LOL!
Construction is fairly straightforward. The folding wings need 8 sewing pins for pivots. 2x small screws required for the front cannons. (They slide in for forward docking on the Ghost).
The rear door will pivot. There are 2x brackets that require fixing on place to hold the pivot shaft. I left them separate otherwise the infill would have made them unusable.
Any suggestions on canopy glass would be welcome. LOL
Once time allows, (meaning finding time to sand it all down,(Damn you PLA!)), I will post construction photos and guide.
Printer Brand:
Anet
Printer:
A8
Rafts:
Doesn't Matter
Supports:
Yes
Resolution:
0,1mm
Infill:
yes
Filament: any PLA White
Notes:
Approx 0.3 Kilo roll used in total. Lots of infill on main bodys. Long print time but worth it.
Lots of support to remove from the main bodies. Be careful.
Designed on Fusion 360.
