by ChristopherB, published
This is an altered version of EdricePrints fantastic "Desk O Bot" that makes it a little easier to print on FDM printers.
Printer Brand: LulzBot
Printer: TAZ 5
Rafts: No
Supports: No
Notes:
No supports needed. Save time by using the included AMF file with all the parts layed out ready-to-print. If laying the parts out by hand, remember to print 4 copies of each half of the leg.
Carefully align and glue each pair of leg halves together
Insert the core into the base. It may be a tight fit so, if necessary, use some sandpaper or a file to clean up the edge.
Check that the legs fit cleanly into the ports on the base. If not, use a file or some sandpaper to trim them down to fit. Use glue to attach each leg to the base.
