by waffleking32
Should look nice with 2 or 3 colors too. Works with 608 bearings.
Make sure you assign the correct extruder to each part after importing into Slic3r PE.
Printer Brand:
Prusa
Printer:
Rafts:
No
Supports:
No
Resolution:
0.25mm
Infill:
10%
Notes:
Used 5 solid top and 5 solid bottom layers
Used archimedean cord top/bottom fill pattern
For the center part, used 0.15mm layer height and 100% solid infill. Looks good with archimedean cord top/bottom fill pattern too.
