by Stewsayer
I remixed Peter3dmaker's great Cartoon Crocodile design by flattening the bottoms of the feet and hollowing it out to allow installation of LEDs inside. I also designed a base for the Croc to stand on that holds a light circuit.
Printer Brand:
Prusa
Printer:
Rafts:
No
Supports:
Yes
Resolution:
0.1
Infill:
10%
Notes:
The Crocodile needs supports. It is best to use a slicer that allows cutomising of support positions. The Tail, the snout, the arms and the cheeks need supports. Place them to avoid creating supports inside the hollow of the figure.
The base requires no supports and should be printed with the closed top down.
Use a transparent filament for the figure. I used Black PETG for the base
The base has two holes.
The sleeve fits into the larger 8mm diameter hole. and will protrude by about 1mm through the top. The hole in the Crocodiles foot will then fit over this sleeve. The LED and wiring can be passed up into the crocodile from under the base through this hole.
The smaller 7mm diamter hole is set to fit a small round push button switch.
There is room in the base for a coin battery, switch and the necessary wiring.
