This is a remix to rotate the girls around so they all roughly facing the same way and looking the same direction. I finally got the tools to agree with what I was attempting. I'm not as happy with the final model as the original repaired version, but it slices fine and prints well so here it is. I hope you enjoy this one as well.
You may find this version a bit more saucy than the previous one. As I was moving the middle girls hands and arms to suit the new stances of the side girls where her hands ended up was a bit more racy than before so I just rolled with it. It was too much work to make her pose more chaste. Hopefully I didn't go too far.
I printed it originally at the small height of 75mm to be sure it would look decent and then again at the full height as can be seen in the photos.
Same caveat before with regard to the pupils and the bad polygons on the eye ridges. They won't slice so you shouldn't have to worry about them. Don't try to repair it, your slicer should be fine with it.
Printer Brand:
Wanhao
Printer:
Rafts:
No
Supports:
Yes
Resolution:
0.1 with 0.3mm nozzle
Infill:
20% Gryoid
Filament: eSun PLA+ Skin
Notes:
Cura 3.6 Tree supports FTW. Only place they kinda didn't work was under the medium hair length girls hair, but the failure was slight.
