by blackonair
Health Bot from Dice Throne season 2, Artificer companion. Modeled off art designed by Manny Trembley. If you are not familiar with Dice Throne, please check it out!
This was modeled in Fusion 360. The Health Bot starts as basic and can be upgraded to advanced. The smaller scopes pop off and larger scopes can be added.
With Cura, I've found the fine setting works best. I did check support to make sure there was wasn't any issues. If you use support, clean up will be needed for parts to fit.
Printer Brand:
Creality
Printer:
CR-10
Rafts:
No
Supports:
Yes
Resolution:
75%
Infill:
10%
Filament: hatchbox PLA white
Notes:
100% is 2 inches , 75% is about 1 1/2, below 75% scaling, you will loose detail
Basic Health Bot
Advanced Health Bot
