by bjorn00025
I made this light bar mount for my Skyteam Dax. The suspension bars are 30 ø the holes are 33 ø so I could put some rubber in between that it wouldn't slip.
I recommend printing it in a way that is the strongest.
Also make sure that when you drive over a bump the suspension doesn't hit the lamp holder.
If you have another light and the bracket doesn't fit you could just design a new beam to work with the side holders
Printer Brand:
Creality
Printer:
Ender 3
Rafts:
Doesn't Matter
Supports:
Yes
Resolution:
0.2 mm
Infill:
60%
Filament: PETG
Notes:
Mine was PETG but u can use another strong fillament don't recommend PLA
Assembly
Remember this is still a plastic not a steel so don't over tighten it.
Materials
10x M6 nylon lock nuts
8x M6 spring washers
300mm M6 wire rod
8x M6x25 Bolt
Some rubber to put inbetween
The light I used:
https://www.amazon.com/YITAMOTOR-Single-Driving-Waterproof-Warranty/dp/B01A6TNWHW?ref_=Oct_DLandingS_PC_7f5d0ffe_NA&smid=A1HUKFKSGZID4U
