This is a Treecko model that I modified to have the arms down and smoothed out some of the rough edges. The original model came from http://roestudios.co.uk/project/3d-pokemon-models/
I did this so I could print some to give out at community day, i figured i would share it in case anyone else wants to print some out for community day.
Printer Brand:
Creality
Printer:
CR-10S
Rafts:
No
Supports:
Yes
Resolution:
.12
Infill:
10%
Notes:
Nothing too special here, there are a lot of supports and I used .12mm z gap (support Z distance in Cura) so it would be easier to remove the supports.
