by voxinaudita
This is a remix of the lovely "Ebony Dagger (Skyrim)" model by Shadowcraft. Thanks, Shadowcraft!
I have made the following changes to the original:
Scaled up the dagger so that overall length is now about 40 cm.
Trimmed the base of the blade and made a hole for it in the handle so it's a bit sturdier and easier to assemble.
Made holes in the tip of the blade so that it fits on the pegs on the blade base.
The finished print shown in the pictures had some supports fail on the handle, and I also had trouble getting the very tip of the blade to print. Both of these issues were with my printer and not the model.
Printer Brand:
Prusa
Printer:
Supports:
Yes
Resolution:
0.2
Filament: 3DFillies ABS
Notes:
A brim is also needed. This print used a brim of 5 mm.
