by wyattjamestl
This is version 1 of my Plague Doctor Mask. It fits my face but has no hole for a strap. The inside of the mask is also very rough as I didn't take any time to model the inside. This was meant to be a display piece so I may do another version which is wearable and has a better interior.
I also included the files for the Plague Doctor Wand I made to go along with the mask.
Printer Brand:
Ultimaker
Printer:
Rafts:
Yes
Supports:
Yes
Infill:
10%
Filament: Ziro, Hatchbox, Amazon Basics PLA
Notes:
NOTE: When I loaded the .stl's onto my printers, I had to scale it to 2540%. The .stl's are in inches.
Used Loctite Super Gel Control super glue on PLA and then a putty to fill the gaps. Sanded down after
