by mike_bright
Hello my friends,
here is my second design. This time an Elven Girl.
I've tried to make her floating ;-) Hope you like it!
The model cannot stand by itself!
Printer:
JGAurora A5
Rafts:
Yes
Supports:
Yes
Resolution:
0,1mm
Filament: OWL Filament PLA Ivory
Notes:
First time I used printing in standing position. But this doesn't work. So I decided to try horizontal. It was okay for printing, but the supports were extremly difficult to remove.
The backside now looks not so detailed because I've given her a new finish with my sanding paper. I'll try it again some time with better support settings.
Any tipps?
The picture shows the model after sanding with 120 - 1500 paper.
Used VAM with a DAZ Base model for pose and proportions. Blender to optimize the model for printing and Cura as a slicer.
