by JimboDLC
Attention All Modelers!
This is one model you will not want to miss out on building!
This is a large model that can be scaled down to fit any printer. You will need to keep track of your print scale to be sure everything will fit properly. You will need your modeling skills to print and assemble this Thing.
You will need:
-PLA Glue of your choice
-Drill Bits
-Sand Paper
-Sanding Block
-Paint of your choice
-Lots of patience
-Sharp knife
Please use the render photos for reference. Some items you will need quantity 4 and others quantity 2. This will not be an easy model to print and assemble. I printed 4 of these before I released this. My grandkid loves this model. If you need a new part - print, fix and go!
Max Dimensions of this model:
13.75 inch Deep
12 inch Wide
5 inch High
Important Notes:
-The propeller is keyed. Check your print down side to be sure its flat on your print bed.
-The Top and Bottom wings are keyed. The holes for the struts are at an angle to help align properly for the fuselage.
-The Long Struts are keyed. Check the angled ends for proper alignment to the wing.
-The axle should move freely in the Wheel Struts. Use a drill bit to enlarge the hole properly.
As usual -
Saved as High Resolution STL files and run through Print Studio before release.
Printer Brand:
Robo 3D
Printer:
Resolution:
.1 or High
Infill:
90%
Filament: Hatch Box 1.75 Red, Yellow, Black
