by vgergo
Some of the components come from other similar designs with improvements.
Movable hands and head.
Intended to be printed in two colors.
Pops together (even the eyes), no gluing needed.
Green:
► head
► body (incl. feet)
► 2 hands
White:
► neck
► body-head link
► 2 eyes
► 2 hand connectors
Printer Brand:
Wanhao
Printer:
Rafts:
No
Supports:
No
Resolution:
Adaptive 0.1
Infill:
15% grid recommended
Filament: DevilDesign, Gembird PETG, TPE White, Green
Notes:
I printed the green parts from flexible TPE. The top of the head tends not to "close" completely, I recommend a thicker top layer (I had it set to 10 layers!)
For the white areas I used PETG (that's what I had, any non-flexible material is ok)
No support, brim or raft needed. You can slightly lower the hands into the bed (1-2mm) to increase adhesion.
I included the slicer screenshots for arrangement. I recommend printing "one at a time" to reduce stringing etc.
The link is a pretty tight fit through the neck, you might want to scale it down a bit.
Also, the eyes will pop in place if you use the flexible/non-flexible material combination. If both are rigid I would also scale down the eyes to 7.7mm x 7.7mm (x/y)
As mentioned above, the connectors and eyes are all designed to go inside flexible material, you might want to scale them down 1-2% if printed out of PLA, PETG or ABS. Alternatively you can file / sand them to make them a tiny bit smaller.
