by blackrice000
Support are not necessary.(supports are including in the model)
So print them are simple.
Attention: ALMA_Dish.stl is larger than 200x200mm^2 without parting.
I will parting it (ALMA_Dish.stl) for normal bed of 3D printer and upload if there is necessary.
Scale : 1/50
Size: about 230mm x 230mm x 280mm (L x W x H)
Support: doesn't matter
Infill: ALMA_Base_White : 10%
ALMA_Dish may set 10% if slice on Cura 15.04.
other are less than 8%
Raft: ALMA_Ladder and ALMA_Platform_2 are need.
The Atacama Large Millimeter/submillimeter Array (ALMA) is an astronomical interferometer of 66 radio telescopes in the Atacama Desert of northern Chile, which observe electromagnetic radiation at millimeter and submillimeter wavelengths. The array has been constructed on the 5,000 m (16,000 ft) elevation Chajnantor plateau - near the Llano de Chajnantor Observatory and the Atacama Pathfinder Experiment. This location was chosen for its high elevation and low humidity, factors which are crucial to reduce noise and decrease signal attenuation due to Earth's atmosphere. ALMA is expected to provide insight on star birth during the early Stelliferous era and detailed imaging of local star and planet formation.
ALMA is an international partnership among Europe, the United States, Canada, Japan, South Korea, Taiwan, and Chile. Costing about US$1.4 billion, it is the most expensive ground-based telescope in operation. ALMA began scientific observations in the second half of 2011 and the first images were released to the press on 3 October 2011. The array has been fully operational since March 2013.
