by Walkyrie222

Another S.P.R.U.E. on the shelf ! (Or should I say under the tree for Christmas ? :p )

This one has been particularly expected and demanded !

Print Settings

Printer Brand:                          

Prusa

Printer:                          

Prusa Mk2

Rafts:                          

No

Supports:                          

No

Resolution:                          

0.2 for main hull parts is enough, but 0.1 or less is highliy recommended for the small parts sprues and weapons !

Infill:                          

20% to 100% (for the smallest parts)

Filament:                                            Prusament PLA                                                                                

Notes:

As usual, I tried to optimize the sprues : not every element is separated as it would be a pain in the ass to print everything piece by piece, but not everything on the same sprue to avoid looong print times as well as to allow for different resolution settings according to the elements you're printing (smaller and more detailed elements are grouped together in this design)

How I Designed This

I took Solutionlesn master job as a starting point and then reworked a LOT many elements (adjusted many parts to correct small errors in alignement and geometry) in order to produce Supportless Print-Ready Ultimate Elements ;) Some might say it's just slicing but it was waaaay more than that !