by ShoeMan
Hey! I think i'm the first to upload these. I searched everywhere and nobody has them. These are ripped, Raw 3D models(higher res). It took me forever to get to this point, but after hours of troubleshooting I have them refined somewhat.
*These are the raw models so you'll have to cut and tweak them a little in mesh-mixer or etc... If you want them to print without using your whole spool on supports. It also wont hurt to smooth out some of the models.
*These are all that I've done so far, I'm printing them around 200mm tall so its about 24hrs each character in separate pieces.
*Let me Know any criticism or helpful thoughts that you guys have!
*Any tips help! And always appreciated!
Printer Brand:
Creality
Printer:
Ender 3 Pro
Supports:
Yes
Resolution:
.12
Infill:
15
Filament: Generic PLA Silver
Notes:
Do not print these as they are! Some mesh's are too thin and some edges are really sharp and don't translate well. You have to edit these in mesh-mixer or other program!
