Summary

In honor of Pokemon Go and my friends going nuts about it, I wanted to model a low poly Pokemon.

You'll need to add some supports so that that hands come out looking good. Please see the picture uploaded for an idea of how you would set the support if you have S3D.

Print Settings

Printer: Delta

Rafts: No

Supports: Yes

Resolution: .300

Infill: Not needed- See notes

Notes:

I am not using any infill on this model. Only three top and three bottom layers along with two perimeters. If you have a problem with bed adheason I would put the model down into the bed 0.5 mm so that you get more surface area on the feet.

How I Designed This

I modeled this using Lightwave.