Loved the model, but the way it was separated made it really hard to print. Rejoined and re-sliced it so that there was always 1 smooth side to placed against the print bed. All pieces uploaded in their preferred print orientation. I found Cura Tree supports best for printing and cleaning this. Also made her taller, at 221mm, but easily printable much larger.
Added connector pieces so that everything lines up and will hold together, even without glue, but super glue will help to hold her together.
Long connector is for thigh. Medium connector is for bra to torso. Short Connector is for arms. Be careful with base to feet connectors. You will likely need to sand all connectors a little a bit with a nail file or something to make them fit. (Maybe print the connector pieces with some negative horizontal expansion...) The base connectors can be fragile and will snap right off the base if you're not careful when merged and separating.
See original model for some build info/instructions.
My Process
I took the original model, which thankfully was uploaded in a way they all connected together. I resliced the thigh to garter connection so there was a flat spot. I resliced the bra to torso so tehre was a flat bottom. I fixed the head so there is a flat side. I remerged and resliced the arms to give a flat side roughly where it was before. I sliced the bottoms of the feet to go with the base. Resliced the paw print out of the base and scaled those so they fit inside and poke out. I tried to change the chest piece in the middle of the bra, but the original works better. Cut tail out of body\panties so it fits and made the tip of it a little longer and flat so it cuts out better and prints easier.
Whole model is scaled up to 221mm tall.
