by o4saken
Cyber punk male.
This is a very high poly model - it is the only way i could get all the details i required.
model is designed to stand infront of an upright wall, book etc depending on size printed.
There are two models uploaded, one where it is fully assembled and one where the cables need to be printed separately and glued in place.
Honestly i would print the one without cables for easier printing - i intend on printing this atleast 600mm tall, so i will need to cut the model up even further, and will definately be using the one with no cables attached. now just to wait till lockdown ends to buy fillament :(
the wall attachments for the separated model (both large and small) would need to be printed 2x.
Supports are definitely required
