by mech-G
Model based on Matt Donie's Batwing Fighter design.
When printed at 100% scale, the finished model is about 12 inches long.
Wings: 0 infill, 2 perimeters, 5 top, 4 bottom, .4mm nozzle, .45mm extrusion width
Engine 10% infill , 2 perimeters, 4 top, 4 bottom, .4mm nozzle, .45mm extrusion width
Fuselage 0 infill, 2 perimeters, , 5 top, 4 bottom, .4mm nozzle, .45mm extrusion width
Stand 25% infill, 2 perimeters, 5 top, 2 bottom, .4mm nozzle, .45mm extrusion width
The engine and wing need to be mirrored to print both left and right.
The engine and wing should be printed with the slotted edge against the build plate.
Put the flat bottom of the stand against the build plate.
The fuselage should be printed vertically as provided. Adjust your cooling settings so that it uses full layer fan, and it slows down to <10mm/s at the small perimeters near the top, to avoid wobbly points. The designed-in supports on the fuselage will need to be cut off by careful scoring with a knife.
Printing at .1mm layer height makes for easier sanding prior to painting.
