by 1cermy
I designed my own model of minecraft steve with a helmet, sword and tool.
Size 66x34x16 mm (2.6x1.34x 0.63 inch)
As a faithful friend, I designed a piggy bank
Size 44x18x29 mm (1.73x0.71x1.14 inch)
If you show the model to children, be prepared to print a lot of steve and a piggy :-)
My daughter likes to see your photos, send feedback. Thanks and enjoy.
NOTE: Trials and errors may occur before you reach the correct settings. Too much plastic will make large joints and supports that stick to the surface and vice versa.
Thoroughly clean the burrs before assembly, lightly coat the joints with harmless cooking oil. After assembly, move slightly. Be careful not to damage the model.
Print Settings
Printer brand:
Prusa
Printer:
i3 MK3
Rafts:
No
Supports:
Yes
Resolution:
0,15
Filament_brand:
Prusament
Filament_material:
PLA
Notes:
For good results, use the usual settings in Slic3r: 0.15mm OPTIMAL MK3: Prusament PLA. I have also prepared Steve.3mf and pig.3mf files for you, which you can use when printing. Simply place the files in your Prusa slicer.
