by onintothevalleyofdeathroadthe600

this is a remix of Ev_Dino's model for Zuko's dagger
https://www.thingiverse.com/thing:4562470

Using iodanem's characters on the blade
https://www.thingiverse.com/thing:4133952

The only change I made to Ev_Dino's model was increasing the blade length. The scabbard is my own creation. You will probably have to sand the top where the pearl goes for a better fit. Blade will probably not fit snuggly. This is my second attempt the first attempt "worked" but i had to heavily sand the dagger's blade before it would fit. hopefully this will work without too much hassle.

Other build notes include making sure you glue the blade into one half of the hilt before glueing the hilt together.

To cover my bases I have included the original scabbard files as well; however, they are only split as I no longer have the entire model. If you do wish to use this version it is recommended that you glue the scabbard together first before any other part. then take the free blade and insert it in as far as it can go without forcing it. Sand all over, except for the tang, until you can get the whole blade in. there should still be a little bit of friction. Then glue the blade and hilt together, as instructed above. Sand the half circle cutout of the scabbard until the two pieces fit. I had a 1/2in diameter rod to wrap my sandpaper around.

Dimensions
Overall: 13 1/2in
Blade (not including tang) 8 1/4in
Hilt: 5 1/4in
Scabbard: 8 5/8th inch

Print Settings

Printer brand:

Creality

Printer:

CR-10

Rafts:

No

Supports:

Yes

Resolution:

0.2

Infill:

20% hilt and scabbard 100% blade

Filament_brand:

Hatchbox

Filament_color:

white

Filament_material:

PLA