by lytta
Padoru model edited for holes and other mesh fixes, a couple detail edits, and parts like the hat and the bow were adjusted so they can print up from the bed. It prints in two parts (plus connector piece) without support (but 50%+ infill recommended.) Also added her present bag. The bottom of the finished model remains not flat; I liked that she wobbles a bit. She's sized in this model and the photo of my print to about 3.5cm tall.
I think there is a hypothetical better optimized version of this that is split at her neck so the face details print vertically, but the details are simple enough that this isn't too bad, imo.
If your connector star doesn't fit, remember you can try to print another one slightly smaller or larger.
Print Settings
Printer brand:
Creality
Printer:
Ender 3
Rafts:
No
Supports:
No
Resolution:
0.12
Infill:
50%
Filament_brand:
Creality
Filament_color:
White
Filament_material:
PLA
