I recently purchased some silver filament, so to give it a little test I designed this axe head and handle. The handle is printed using the wood filament and the two pieces can either be friction fitted or superglued together
Printer:
Wanhao Duplicator i3
Rafts:
No
Supports:
Yes
Resolution:
1.5mm
Infill:
30
Notes:
Axe Head - Orient so that the "blade" is up in the air and the back is on the build plate, this does not need any supports because the curve angle of the hole
Axe Handle - This will need some support because the part where the head and handle interface is raised slightly, but it is easily removed and actually helps with the friction fit
