first of all: my english isnt that good...
Iam a more or less good creator of 3D-arts and animations and i wanted to print some of my models, here we have Lola from Spacejam. To print her you need alot support, in fact the support needs more material than the figure self.
The support around her ears is very difficult, i made on my first lola not enough supports so the eartips didnt hold there and on secound time i made too much support that i ripped the eartip and the hand off as i tryed to remove it.
Ive printet her at 150% size with 80mm/sec, 2 outlines and 20% infill in around 6 hours.
The Model was created by Shadowsquirrel and rigged by a want-to-be-anonymous-friend
Printer Brand:
RepRap
Printer:
Anet A8 with watercooled Bowden
Rafts:
Doesn't Matter
Supports:
Yes
Resolution:
0.2
Infill:
20
