Please read "Pharah Instructions.pdf" for details. Seriously. They're too long to fit here. This is not a print I would recommend to a new user--experienced hands only! This is not a "set and forget" project.
If your build volume is smaller than a FlashForge Creator Pro--8.85 x 5.7 x 5.9 in (22.5 x 14.5 x 15 cm)--you cannot make this unless you break the files down into smaller pieces.
Printer:
PowerSpec 3D Pro
Rafts:
No
Supports:
Yes
Resolution:
0.1mm
Infill:
30%
Notes:
Some parts need support, others don't. Use common sense. (See above about experienced makers only!) Details in the PDF.
The PowerSpec 3D Pro is a re-badged FlashForge Creator Pro.
Finished.
Top view.
Seated.
Close-up.
