edit I am calling this a failed print. There is just too much to cleanup on the part.
I halved the Dragon skull and resized it to fit the bed of a Micro3d. I also added a 7mm (~1/4in) hold for a magnet at the base of the skull. This was mostly just a test part for learning how to cut up a model to fit the Micro3d's tiny print bed. I recommend printing it with supports, but I'll admit that the test print is 30 minutes into a 9 hour print at time of posting this.
Changes I might make: I wish I had thrown this into Meshmixer to hollow out before I halved it. Also, It might have been a good idea to add a ball socket so this could be popped onto an action figure of some kind.
Also, I think if this turns out well I'll try a T-Rex skull, and look for a skeleton body to go with it.
Printer:
Micro3d
Rafts:
Yes
Supports:
Yes
Resolution:
user preference
Infill:
user preference
