Dragonball Z Scouter - Based on the model worn by Vegeta during the Saiyan Saga.
Scouter is held together using Low Profile Hex Screws (M3 x 12mm) and Nyloc Nuts, specifically the ones found here at ACCU Group:
https://www.accu.co.uk/en/low-head-cap-screws/8723-SSCL-M3-12-A2
https://www.accu.co.uk/en/hexagon-nylon-locking-nuts/7944-HNN-M3-A2
Was modelled to fit my head but should fit others.
The speaker grille was modified from when the Renders were run because it was difficult to print so many tiny holes.
Thanks
Alex
Printer:
Cronos-FDM - Spec-1
Rafts:
No
Supports:
Yes
Resolution:
0.1mm Layer Height
Infill:
15%
Notes:
If you print the cover laying down with supports then print using a low layer height for a nicer top curve.
