YellowScope is Proud to Announce the YellowScope YS-2. An articulated Print in place robot model. This is one of my first full designs. So, any input is greatly appreciated. I would love to pictures if anyone prints this!
Printer:
Monoprice Mini Select
Rafts:
No
Supports:
No
Infill:
Tested at 10%
Notes:
I've printed this with a .175 layer height, and 3 Layer Walls with best results.
I use some pretty tight clearances for some of the joints so a properly tuned printer is important.
Remove the two build in supports on the back of the Arms
I had to use two small built in supports in order to improve my success rate.to Remove them, simply bend them up and down until they break, This should leave very minimal markings on the print.
This Model was completely Modeled by hand using Fusion 360.
I did take some inspiration from the Makerbot, as well as the Print-in-Place KILLBOT mini so a special thanks to their creators as well.
http://www.semaker.com/productdetail/891
