This model was designed with the aesthetic of a CD rack in mind. I like the look of the towers of angled discs, and decided to make my own, albeit not quite as big. Each rack holds 10 DS cartridges and comes in only two parts that snap together very satisfyingly.
Though all that appears is the white Nintendo DS header that is present on each card, I think it provides a nice sense of uniformity, apart from the bottom most game, which shows just barely and gives it a nice pop!
Printer Brand:
FlashForge
Printer:
Finder
Rafts:
Doesn't Matter
Supports:
No
Resolution:
.18mm
Infill:
15%
Notes:
The infill percentage doesn't matter much, since the walls are pretty thin.
Rotate the rack so it stands upright, and have the top lie flat.
All three prints above are each slightly different. The red rack I designed first, but made the finger joints a bit small, with each "finger" being about 1.5mm^3. The tolerances of my printer were a little less tight than expected.
Two more tries with tweaking the measurements, and the top fit perfectly! though the final prototype has some burnt filament from me forgetting I paused the print.
